Magnetek Flex 12EX System Instrukcja Użytkownika Pobierz pdf (Strona 5)

Page 4

2. Radio Controlled Safety

Flex radio remote control system should be operated by persons with sufficient amount of knowledge

and skill in crane operation and safety. Persons being trained to operate a radio remote controlled crane

should possess the knowledge of all hazards peculiar to radio remote controlled crane operation, ability to

judge distance and moving objects, equipment capacity and radio remote controlled safety rules. Radio

remote controlled cranes should not be operated by any person with insufficient eyesight, hearing, illness,

and under influence of drugs and medications that may cause loss of crane control.

Below are some general operating safety tips that should be strictly followed when operating a radio

remote controlled crane.

1. Prior to crane operation always check the transmitter handset for any damage that might inhibit proper

crane operation.

2. Always check if the red emergency stop button is working properly prior to crane operation.

3. Check the Status LED on the transmitter for any signs of low battery power (refer to page 31).

4. Check the Status LED on the transmitter for any signs of irregularities (refer to page 31).

5. The crane limit switches should be checked prior to crane operation or at the beginning of each shift.

When checking limit switches the hoist should be centered over an area free of personnel and

equipment.

6. If the power to the crane is removed, the operator should turn off the transmitter power immediately

until the power to the crane is restored.

7. If the crane fails to respond properly to operator’s command the operator should stop operation, turn

the transmitter power off, and then report the condition to their supervisor.

8. The transmitter power should be turned off after each use. If the transmitter handset is not in use

always turn the power off and stored it in a safe or designated location. Never leave the transmitter

handset unattended in the working area.

9. Make sure the system is not set to the same channel as any other Flex systems in use within a distance

of 300 meters (900 feet).

10. Never operate a crane or equipment with two transmitter handsets at the same time unless they are

programmed with “Pitch & Catch” function. For information on the “Pitch & Catch” feature, please

refer to page 19 and page 30 of this manual.

1 2 3 4 5 6 7 8 9 10 ... 36 37

Brak uwag

Magnetek Flex 12EX System Instrukcja Użytkownika Strona 5