Magnetek Flex 12RS System Instrukcja Obsługi Pobierz pdf (Strona 12)

Flex PRO / Flex M Pre-Engineered Radio Control System Instruction Manual

April 2012

Page 12 of 42

2.12. SPECIFIC SYSTEM WARNINGS

Below are some specific operating safety tips that should be strictly followed when operating a Flex Pro

system:

1. Check the Status LED on the transmitter for any signs of low battery power (refer to Section

11.1).

2. Check the Status LED on the transmitter for any signs of irregularities (refer to Section 11.1).

3. Make sure the system is not set to the same channel as any other Flex systems in use within a

distance of 300 meters (900 feet).

4. Never operate equipment with two transmitter handsets at the same time unless they are

programmed to do so.

2.13. FLEX M RECEIVER INSTALLATION

WARNING

BEFORE OPERATING THE RECEIVER FAMILIARIZE YOURSELF WITH ALL SAFETY INFORMATION IN THIS

MANUAL, APPROPRIATE MANUAL SUPPLEMENTS AND ANY OTHER LOCAL, STATE, OR FEDERAL RULES OR

REGULATIONS ALREADY IN EXISTENCE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS

INJURY OR DEATH AND DAMAGE TO EQUIPMENT.

2.14. PRE-INSTALLATION

Transmitter and receiver access code and channel must match before the system will communicate.

2. Be aware of other radio channels in the surrounding area - set your system to a unique channel.

3. Make sure that your equipment is working properly in manual mode prior to system installation.

4. Make sure the power to the receiver is the correct voltage.

5. Disconnect equipment power prior to system installation.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 41 42

Brak uwag

Magnetek Flex 12RS System Instrukcja Obsługi Strona 12