Magnetek Enrange CAN-6 Informacje Techniczne Pobierz pdf (Strona 41)

Enrange MHR Instruction Manual

August 2014

Page 40 of 57

5.0 OPTIONAL PROGRAMMING WITH RCP

Using the optional RCP software makes programming of the MHR easier and allows for settings

to be saved for future reference.

WARNING

THE USE OF RCP (RADIO CONTROL PROGRAMMER) IS INTENDED FOR USE BY AUTHORIZED

PERSONS ONLY. CHANGES TO ANY RADIO DATA VALUE MAY LEAD TO UNEXPECTED,

UNDESIRABLE, OR UNSAFE OPERATION OF EQUIPMENT AND FURTHERMORE MAY LEAD TO

EQUIPMENT DAMAGE, PERSONAL INJURY, OR EVEN DEATH. ALL EQUIPMENT OPERATORS

AND/OR PERSONNEL SHOULD BE NOTIFIED OF ANY RADIO DATA VALUE CHANGES THAT MAY

AFFECT OPERATION.

5.1 ACCESS CODES

The receiver and transmitter must be programmed with the same access code to properly

communicate with each other.

WARNING

TWO OPERATIONAL TRANSMITTERS WITH THE SAME ACCESS CODES OPERATING AT THE SAME

TIME IS A DEFINITE SAFETY HAZARD – DO NOT OPERATE THEM AT THE SAME TIME. FAILURE TO

FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO

EQUIPMENT.

5.2 CHANGING TRANSMITTER ACCESS CODES

Transmitter Access Code Programming. For detailed instructions on setting parameters,

including access codes, see the “Programming” section of the applicable transmitter manual.

WARNING

AFTER CHANGING THE ACCESS CODES ON THE TRANSMITTER, TEST THE UNIT BY TURNING IT

ON AND OFF NEAR THE APPROPRIATE RECEIVER. IF THE RECEIVER DOES NOT RESPOND, DO

NOT ACTIVATE A FUNCTION BUTTON! THE TRANSMITTER MAY HAVE THE WRONG ACCESS CODE,

WHICH COULD MOVE OTHER EQUIPMENT. RE-CHECK THE ACCESS CODE IN THE TRANSMITTER

AND RETEST. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR

DEATH, AND DAMAGE TO EQUIPMENT.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Brak uwag

Magnetek Enrange CAN-6 Informacje Techniczne Strona 41