Magnetek Enrange CAN-6 Instrukcja Obsługi Pobierz pdf (Strona 30)

Flex 8EX System Instruction Manual

December 2013

Page 30 of 44

RELAY FUNCTIONS

1 324 756 8

4.2.4 Dip-Switch Settings

4.2.4.1 Interlocked Functions

Interlocked means the two adjacent push buttons cannot be activated simultaneously as

they will cancel each other out. Interlocked settings are usually applied to a crane’s

forward and reverse motions. Each dip-switch on the decoder module corresponds to

one (1) motion or two (2) adjacent push buttons (refer to Fig. 14 & 15 below). Only the

first seven (7) dip-switch positions are used (counting from left to right); the 8

dip-switch

position (far right) is not used.

(Fig. 14) (Fig. 15)

▇ Manufacture preset

Dip

Settings

Function Descriptions

# of Relays

Used

0000000 Normal (single speed only, F2 & R2 relays not used).

0000001

Closed/Closed Relay Action at 2

Speed (separate 2

speed

relay).

0000010

Closed/Closed Relay Action at 2

Speed (shared 2

speed

relay).

0000011

Opened/Closed Relay Action at 2

Speed (separate 2

speed

relay).

0000110 On (right button) & Off (left button).

0001000

On & Off affected by the E-stop command. When E-stop

command is initiated, the Off relay is activated.

0001001

On + Start / Off + Start -- Prior to pressing the button you must

first rotate and hold the power key switch at START position to

activate On or Off relays.

0001010 FWD/REV toggled (latched).

0001011

FWD/REV toggled (latched) and affected by the E-stop

command.

0000111 Safety Magnet On & Off.

0100001 Closed/Closed + Brake.

0100010 Closed/Closed Relay Action + Brake.

0100011 Opened/Closed Relay Action + Brake.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Komentarze do niniejszej Instrukcji

Brak uwag

Magnetek Enrange CAN-6 Instrukcja Obsługi Strona 30

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Pomiary, testowanie i kontrola Magnetek Enrange CAN-6