Magnetek Enrange CAN-6 Instrukcja Obsługi Pobierz pdf (Strona 40)

Flex 8EX System Instruction Manual

December 2013

Page 40 of 44

PITCH

7.1.4 Pitch & Catch Operating Procedure

To release control of the crane, press the “Pitch” push button. To take over control of the

crane, rotate the power key switch to the “Catch” position for up to 2 seconds. The second

operator cannot take control of the crane unless the first

operator presses the “Pitch” push

button (2.0 seconds). If the operator unintentionally presses the “Pitch” push button during

operation, just rotate the power key to the “Catch” position for up to 2 seconds to regain

control.

→ →

7.1.5 Automatic Channel Scanning Operating Procedure

After changing the transmitter channel (refer to page 17), turn on the transmitter power,

rotate the power key switch to the “Start” position, and hold it there for up to 1 minute. Within

this 1-minute period the receiver will search (channel 01 ~ channel 62) and lock onto the

newly selected transmitter channel automatically. Please note that in order for the receiver to

switch to auto-scanning mode, you must first deactivate the receiver MAIN by shutting off

the transmitter power or press down the emergency stop button before changing the

transmitter channel. Please refer to page 29 if you do not want the receiver to auto-scan all

62 channels.

Change Transmitter Channel →

7.1.6 Changing Transmitter Batteries

Change the transmitter batteries by unscrewing the battery cover located on the backside of

the transmitter (refer to Fig. 20 below). During battery installations make sure that the blue

ribbon is centered between the two batteries. After changing the batteries make sure that all

screws are tightened to avoid water, moisture, dirt, grease, or other liquid penetration.

(Fig. 20)

↓

1 2 ... 35 36 37 38 39 40 41 42 43 44

Brak uwag

Magnetek Enrange CAN-6 Instrukcja Obsługi Strona 40